Just Flight - PA-28-161 Warrior (FSX/P3D)

Product Changelog

Warrior FSX, P3D Changelog
Latest Update: 01/02/2021   The below log shows all updates for this product since release: v1.05 - Fixed Flight1 GNS 430 not being clickable v1.04...
Mon, 1 Feb, 2021 at 12:38 PM

FAQs

My Aircraft Loads Without Full Oil And Battery Charge
To simulate the operation of the real aircraft, the engine oil and battery charge are recorded whenever you stop flying the Warrior II and these will then b...
I Am Unable To Start The Engine
Please check the following items: Fuel flow - To ensure sufficient fuel flow for ignition, confirm that the fuel pump is switched on and the mixture lever ...
How Can I Refill The Engine Oil And Recharge The Battery?
The engine oil and fuel can be refilled, and the aircraft battery recharged, from the refill menu. This menu can be accessed whilst the aircraft is parked w...
Why Is The Low Voltage Warning Light Illuminated?
The low voltage warning light will illuminate if: The electrical bus voltage drops below approximately 12.5 volts The engine is left below 1000 RPM f...
How Do I Enable The Flight1 GTN 650/750 And GNS 430/530?
For optimal performance we have included a switcher tool (PA28 Warrior Model Switcher), located in the Start Menu, which allows you to switch between three ...
My Aircraft Always Loads With The Engine Running
The aircraft will load up in a 'ready for takeoff' state unless: You are loading a previously saved Warrior II flight, in which case the airc...
The Fuel Pump And/Or Turn Coordinator Gyro Are Too Loud
The fuel pump and turn coordinator gyro sounds were recorded from the real aircraft, however we have included an option to disable these sounds if desired. ...