Just Flight - VC10 Jetliner
Product Changelog
Latest Update: 09/02/2018 The below log shows all updates for this product since release: v1.04 - VMO needle on ASI – fixed - New standby altimete...
Wed, 2 Jan, 2019 at 11:16 AM
FAQs
To automatically configure the aircraft in either a cold & dark or ready for takeoff state, navigate to Add-ons > Just Flight VC10 Jetliner using the...
The horn is a takeoff configuration warning. Before advancing the throttles for takeoff, please ensure that: The flaps are set to the T/O position The ...
A ground air supply must be connected to the aircraft before the first engine can be started. Navigate to Add-ons > Just Flight VC10 Jetliner using the i...
The associated yaw damper must be switched on before the autopilot can be engaged using the switch located on the centre pedestal. The associated power swit...
The yokes can be hidden using the remove yoke (R.M YOKE) switch which is located on the centre pedestal, between the aileron trim controls and autopilot con...
The system B tail-plane trim lever can be used to control the elevator trim setting. The lever is spring-loaded to the centre position. Click-and-drag the l...
A variety of ground equipment can be toggled using the ground crew jack control switch located on the rear bulkhead panel. The switch can be operated from t...
Once altitude hold mode has been engaged there are two methods for changing the altitude that the autopilot holds:
Rotate the datum adjust knob (locate...